VMProtect Software » Forum

I'm using script from documentation to get markers for code which need to be protected.
When vmp project compiles from console, I have got multiple subject messages for some functions, but not for all.

Also, I have got "Found 21 unpaired markers".

When I try to load vmp project into GUI, I have got a lot of message boxes with the same message, but I can't find any details about problem

Bernd wrote:I'm using script from documentation to get markers for code which need to be protected.
When vmp project compiles from console, I have got multiple subject messages for some functions, but not for all.

Also, I have got "Found 21 unpaired markers".

When I try to load vmp project into GUI, I have got a lot of message boxes with the same message, but I can't find any details about problem

Check the markers in your code , maybe you are missing one or two or just not in the correct order > vm_begin vm_end