"Invalid command address" problem

x22x22 · Post by **x22x22** » Tue Aug 13, 2019 4:21 pm

I see "Invalid command address" error while compiling on the compilation log section.
This problem occurs when I enable debugger detection.

P.S: This problem is not connected just with debugger detection, also, occurs when I enable any protection method on vmp.

Post by **Admin** » Wed Aug 14, 2019 7:20 am

Please send us a test example.

x22x22 · Post by **x22x22** » Thu Aug 15, 2019 11:07 am

It was sent to [email protected].
Please check your mailbox.

x22x22 · Post by **x22x22** » Fri Aug 23, 2019 3:16 pm

Problem still continues please check it asap.

Post by **Admin** » Sat Oct 26, 2019 5:01 pm

Please try the 1167 build.

VMProtect Software » Forum