VMProtect Software » Forum

Posted: **Tue Aug 13, 2019 4:21 pm**

I see "Invalid command address" error while compiling on the compilation log section.
This problem occurs when I enable debugger detection.

P.S: This problem is not connected just with debugger detection, also, occurs when I enable any protection method on vmp.

Posted: **Wed Aug 14, 2019 7:20 am**

Please send us a test example.

Posted: **Thu Aug 15, 2019 11:07 am**

It was sent to [email protected].
Please check your mailbox.

Posted: **Fri Aug 23, 2019 3:16 pm**

Problem still continues please check it asap.

Posted: **Sat Oct 26, 2019 5:01 pm**

Please try the 1167 build.

"Invalid command address" problem